Credible well pump installation and replacement in Bowmanville

Well pumps are the backbone of your water supply system, providing the energy needed to bring water to your house or water tank. As a part of the well that runs on a daily basis, the pump is subject to breakdowns. If you need to install a new well pump or replace an existing one that has stopped working, turning to Superior Plumbing & Heating is a good idea! We have the resources to tackle a wide variety of well pumping issues, and we will strive to provide a solution to your plumbing concern that is perfectly suited to your home’s needs.

The severity of the issue will determine how long it will take to replace the pump. Normally, it takes our crew about 2 – 4 hours to inspect, diagnose the device and start the work. Sometimes it may take longer due to other nuances like power outages, pipe damage, or surrounding soil issues. The whole procedure is normally finished the same day we get your application! We guarantee top-notch well pump replacement & installation services in Bowmanville at reasonable prices. You can count on us for superior performance of your newly installed equipment!

Efficient Well Pump Troubleshooting

Let’s have a look at some common signs and steps you may undertake to repair or replace a well pump in case of failure:

  • Dirty water (such equipment is not meant to pump water with lots of sand and other sediments, as wear and tear can cause the unit to fail, and replacement of the equipment will be the only solution);
  • A low or dry well (when your house or storage tank is in need of water, a signal is given to the device to get it from the well; in case the well is dry or has an insufficient amount of water in it, the equipment will try to get water out of the well, causing it to overheat and pump motor will eventually burn out);
  • Decreased water pressure (clogged water lines might be to blame, severe clogs will require pipe replacement; your unit may not be capable of managing the load – optimal flow index is 5 gallons per minute);
  • Spitting faucets (it is an explicit sign that your device is defective and needs inspection; check for a break in the water pipe above the well – a hole in the water pipe adds unwanted air to the system);
  • Increased electricity bills (it may indicate that your pump is running non-stop – this could be because dirt and other deposits are clogging the pump, forcing it to run for long periods of time; there may also be little water in the well).

When it comes to well pump troubleshooting, you may have no choice but to call a professional service company. Some units, such as deep well jet or submersible water pumps, require sophisticated equipment to remove them without breaking components or pump wiring. In addition, removing a pump can be very time-consuming, as some units weigh more than 100 pounds and are placed 25 feet deep. At Superior Plumbing & Heating, we know exactly how to install a deep well or above-ground pump and other complex equipment. We diagnose well pumps thoroughly and offer the best and the most affordable replacement solutions, so should you notice any of the warning signs listed above or just want your equipment inspected – wait no longer to contact us!

How long do well pumps run?

The average lifespan is 8 to 15 years, although a lot of homeowners note that with proper maintenance, their equipment lasts much more than that, often 20 to 30 years! To get the most out of your well pump, we highly recommend it to ensure its professional installation and maintenance. We at Superior Plumbing & Heating provide a range of services, including well drilling, well and pump service, water treatment system installation and maintenance, as well as design and installation of custom water well systems.

No need to google “well water pump replacement and service near me” with our dedicated team at hand!

Well pump replacement & installation cost in Bowmanville

The average cost of well pump replacement will vary depending on several factors, the size of the unit and its type being the major ones. For instance, a submersible stainless steel well pump installation will be more expensive than a jet pump for a shallow well. Additional parts, like check valves to avoid backflow into the pump, are standard on submersible models and add to the replacement cost.

Installation rates can also range depending on numerous factors such as well depth, type of pump, your location, equipment needed and even the topography of your yard. Asking specialists for a quote is the best way to get accurate pricing information.

Superior Plumbing & Heating delivers well pump replacement and installation at the most competitive cost in Bowmanville. We value our customers and want to satisfy their needs at any budget. Top-quality service doesn’t have to be costly; that is what we prove daily!

Why us?

Superior Plumbing & Heating is a well-established, experienced and trusted company with hundreds of loyal customers around the area. We know every single thing there is to know about wells and pumps, offer a 3-month warranty and believe in doing our job right the first visit. Rather than search “well pump installation and replacement near me,” contact us and get to know what outstanding service is!