Call us and we’ll come to you 
What a Real Furnace Tune-Up in Ottawa Actually Covers
A lot of companies call a filter swap and a five-minute look a “tune-up.” Ours is a full inspection and cleaning across four areas of the system, and we’ll show you exactly what was checked — because that’s the whole argument against a rushed, bare-minimum visit. 
Combustion and safety. Heat exchanger inspected for cracks or corrosion, burners cleaned, ignition system tested and adjusted, flame sensor cleaned, gas pressure and valve checked, draft and venting inspected, safety switches tested.
Airflow and mechanics. Blower motor and bearings inspected and lubricated, blower wheel cleaned, belt checked where applicable, air filter inspected and replaced, airflow measured, ductwork visually checked for obvious leaks.
Controls and electrical. Thermostat calibrated and function-tested, control board diagnostics run, electrical connections tightened and checked, condensate drain and trap cleaned on high-efficiency units.
Final verification. Carbon monoxide tested at the furnace and throughout the home, full system cycle run before we call it done.
This is furnace cleaning and furnace inspection handled as one job, not two upsells — and it’s why our furnace tune-up in Ottawa takes real time on-site, not a rushed fifteen minutes.
The Carbon Monoxide Test: The One Thing You Can’t Check Yourself
Every other item above, a determined homeowner could theoretically attempt. This one, you can’t. A cracking heat exchanger can leak carbon monoxide into your air supply without a single visible symptom — no smell, no smoke, nothing your senses will catch. Our technicians test CO levels at the furnace itself and at supply vents throughout the home with calibrated equipment, on every single visit, no exceptions and no upcharge. If a reading comes back elevated, we show you the number and explain what it means before we explain what it costs to fix.
What We Often Catch Before It Becomes a Breakdown
The value of annual furnace maintenance in Ottawa shows up most in what it prevents:
A hairline crack starting in the heat exchanger. Caught early, it’s a documented finding and a conversation about timing — sometimes a scheduled fix, sometimes a sign that furnace replacement is the smarter call before a safety issue develops. Missed, it’s a carbon monoxide risk discovered the hard way.
A worn ignition component nearing failure. Igniters and flame sensors degrade gradually — a tune-up catches the “starting to struggle” stage before it becomes a no-heat emergency and an urgent furnace repair call.
Blower bearings drying out. A humming or grinding noise that hasn’t shown up yet is often a bearing on its way there. Lubricated and caught early, it’s routine maintenance. Ignored, it’s a seized blower motor and an urgent service call instead of a scheduled visit.
Every finding is documented and shown to you — photos where relevant — with an honest read on urgency. Nothing gets “discovered” as a surprise upsell mid-visit.
Save More with Our HVAC & Plumbing Membership
Furnace maintenance is exactly the kind of service our HVAC & Plumbing Membership is built for — it applies to the systems and appliances covered under the plan, including your furnace, and members save on both repairs and maintenance going forward.
- 10% off eligible services on the appliances and systems covered by your plan
- Covers both HVAC and plumbing — one membership, the whole home
- Backed by our standard workmanship warranty on all work performed
See our Membership Plans page for full details and terms.
